(Peter Bertini)
Hi Peter,
Thanks so much for your troubleshooting suggestions.
U12 74HC74 working. Pin 5 = 5Mhz output & pin 9 = 10Mhz output
U13 MC145170 (PLL) some odd things happening. Digital pulses, unequal pulse
width, on pins 14 & 15.
Pin 7 (Clk in) +/- 200mV sinewave, pin 8 (D out) - no digital signal.
The data sheet talks about this part being programmable. I'm not familiar with
this part at all. I expected to see a digital pulse on pin 7.
Do you know the level of the sinewave requirement for the uP pin 19 (xtal 1)?
Since the 74HC74 & the uP obtain the clock from transistor Q2, I assume it's
okay.
Any additional help in chasing this issue would be much appreciated.
Greg W2GLS (Gregory Smith)
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|