Thanks yours Barry regrettably my test equipment is very limited and looking
inside the O-6 certainly looks a lot more formidable than my dear old Corsair2
along with the added problem of age (78) and failing eyesight say no more...
Will have a go at the receive chain simply bridging the antenna by following
the diagram..
Bear with me..
73
Malc/F5VBU
----- Original Message -----
From: Barry N1EU
To: Discussion of Ten-Tec Equipment
Sent: Thursday, September 07, 2017 4:13 PM
Subject: Re: [TenTec] Omni VI
Are you able to inject a 50uV signal into the antenna jack and trace it
down the receive chain? Do you you have test equipment?
Barry N1EU
On Thu, Sep 7, 2017 at 9:59 AM, Malcolm McLeman <f5vbu@cegetel.net> wrote:
> For inclusion in the TenTec Omni VI forum...
>
> Comparing normal band condx with my FT102, my Omni VI receiver has
> suddenly died though the transmit side works as per normal..
> I can also pick up the cw output from a very QRP signal from my FT102..
> Have tried all the usual permutations with antenna connections etc Omni
> factory reset and dc check on the T/R relay on the band-pass filter board..
> I'm rather stuck on where to go next and wondered if any-one may have an
> answer..
> 73
>
> Malc/F5VBU
>
> NNNN
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|