Please cancel below as I may have given misleading information... will get back
again when verified...
Apols for inconvenience... Malc/F5VBU
----- Original Message -----
From: Malcolm McLeman
To: tentec@contesting.com
Sent: Thursday, September 07, 2017 3:59 PM
Subject: [TenTec] Omni VI
For inclusion in the TenTec Omni VI forum...
Comparing normal band condx with my FT102, my Omni VI receiver has suddenly
died though the transmit side works as per normal..
I can also pick up the cw output from a very QRP signal from my FT102..
Have tried all the usual permutations with antenna connections etc Omni
factory reset and dc check on the T/R relay on the band-pass filter board..
I'm rather stuck on where to go next and wondered if any-one may have an
answer..
73
Malc/F5VBU
NNNN
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|