Are you able to inject a 50uV signal into the antenna jack and trace it
down the receive chain? Do you you have test equipment?
Barry N1EU
On Thu, Sep 7, 2017 at 9:59 AM, Malcolm McLeman <f5vbu@cegetel.net> wrote:
> For inclusion in the TenTec Omni VI forum...
>
> Comparing normal band condx with my FT102, my Omni VI receiver has
> suddenly died though the transmit side works as per normal..
> I can also pick up the cw output from a very QRP signal from my FT102..
> Have tried all the usual permutations with antenna connections etc Omni
> factory reset and dc check on the T/R relay on the band-pass filter board..
> I'm rather stuck on where to go next and wondered if any-one may have an
> answer..
> 73
>
> Malc/F5VBU
>
> NNNN
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|