TenTec
[Top] [All Lists]

Re: [TenTec] N1 and N2 slots

To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Subject: Re: [TenTec] N1 and N2 slots
From: Barry N1EU <barry.n1eu@gmail.com>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Sun, 13 Aug 2017 15:03:36 +0000
List-post: <mailto:tentec@contesting.com>
I would go with these settings:

s1-1 off
s1-2 off
s1-3 on
s1-4 on

Push in your "NAR" filter switch to engage the roofing filter.

Barry N1EU


On Sun, Aug 13, 2017 at 2:42 PM, Stan Gammons <s_gammons@charter.net> wrote:

> On 08/13/2017 05:25 AM, Barry N1EU wrote:
>
>> Stan, do you have the ssb (2.4KHz) or cw (600Hz) roofing filter?  What
>> filter do you plan on using in the NAR slot?
>>
>> This is the info needed to determine the dip switch settings on the
>> roofing
>> filter board.
>>
>> Barry N1EU
>>
>>
>>
>
> Hi Barry,
>
> I have the SSB roofing filter.  For now I'm not planning on putting a
> filter in the NAR slot.
>
>
>
> 73
>
> Stan
> KM4HQE
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>