On 08/12/2017 09:37 PM, Ken Brown wrote:
If you have a Omni VI+ or a later Omni VI that was upgraded it will have
two optional narrow 9 MHz IF filter slots, which are selected by the N1 and
N2 buttons. You can use one or the other, or none, but not both. Again the
2.4 kHz "non-option" filter is always in use for both TX and RX..
Hi Ken,
It has the 9 Mhz IF board with 2 filter positions. One has a 2.4 Khz
filter and the position maked optional has no filter. N1 and N2
buttons? There are no buttons on the front panel marked N1 and N2. So,
I'm kind of lost...
73
Stan
KM4HQE
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|