Stan, do you have the ssb (2.4KHz) or cw (600Hz) roofing filter? What
filter do you plan on using in the NAR slot?
This is the info needed to determine the dip switch settings on the roofing
filter board.
Barry N1EU
On Sun, Aug 13, 2017 at 1:50 AM, Stan Gammons <s_gammons@charter.net> wrote:
> Hi All,
>
> I have an Inrad roofing filter mod for the Omni VI and I'm unsure what it
> means on the N1 and N2 slots. I assume the N1 slot is the standard 9 Mhz
> IF filter and N2 is the optional 9 Mhz IF filter? I'm also unsure what the
> instructions mean when it says some early Omni VI had only one narrow
> switch. The Omni VI I have was made in Nov 1996, if I read the SN right,
> but all I see is 2.4, 1.8, .5, .25 and NAR. So, is 2.4, 1.8, .5 and .25 N1
> and NAR N2?
>
>
> 73
>
> Stan
> KM4HQE
>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|