I’d suspect the “T” and “R” voltages and the switch over on the control board.
Check their levels. If they (or one) is between values i.e. +12 on rec is no
+4, that could screw things up
Mike, WB8VGE
“The trouble with quotes on the Internet is that you never know if they are
genuine”
—Abraham Lincoln
> On Apr 13, 2017, at 10:58 AM, Curt Benjamin via TenTec
> <tentec@contesting.com> wrote:
>
> Tom, find out if there’s a signal missing when it quits – i.e. PTO or
> something. If it affects receive and transmit on all bands, I would say it’s
> not a pre-mix oscillator for one band,but something common. It also could be
> a DC voltage missing. I don’t have the manual in front of me to see what it
> could be – I’ll have to wait until I’m done with work. This seems like it
> would be a easy fix if you could think it through and take some measurements
> with the forum’s help if needed.
>
> Curt, K8AI
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|