I agree that would be fantastic,
Best 73, Steve W1DXH
-----Original Message-----
From: Barry N1EU <barry.n1eu@gmail.com>
To: Mike Dishop <n8wff@yahoo.com>; Discussion of Ten-Tec Equipment
<tentec@contesting.com>
Sent: Tue, Feb 21, 2017 7:23 am
Subject: Re: [TenTec] New Discussion Orion III Survey question
Yes Mike, the Orion III can DEFINITELY use the same front panel.
73, Barry N1EU
On Tue, Feb 21, 2017 at 3:36 AM, Mike Dishop via TenTec <
tentec@contesting.com> wrote:
> Without any distraction or off topic replies, I want to know if the Orion
> III can use the same front panel with the same controls and features /
> buttons/ knobs and user interface.
> The screen will be different, the guts will be different, the box may be
> different, and all of this does not matter.
> All I want to know is if I can use the same expensive injection mold for
> the front. If the answer is no then we will have to use a painted front
> like certain other people use.
> This is not telegraphing that an O3 is eminent, under development or any
> other speculation. Is the O2 front panel OK or not OK. that is all I want
> to know.
> 73 DE N8WFF
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|