Absolutely use the existing front panel. I'm so used to my Oll that the
transition would be easy.
Andy, W3LI
________________________________
From: TenTec <tentec-bounces@contesting.com> on behalf of Mike Dishop via
TenTec <tentec@contesting.com>
Sent: Tuesday, February 21, 2017 3:36 AM
To: Discussion of Ten-Tec Equipment
Cc: Mike Dishop
Subject: [TenTec] New Discussion Orion III Survey question
Without any distraction or off topic replies, I want to know if the Orion III
can use the same front panel with the same controls and features / buttons/
knobs and user interface.
The screen will be different, the guts will be different, the box may be
different, and all of this does not matter.
All I want to know is if I can use the same expensive injection mold for the
front. If the answer is no then we will have to use a painted front like
certain other people use.
This is not telegraphing that an O3 is eminent, under development or any other
speculation. Is the O2 front panel OK or not OK. that is all I want to know.
73 DE N8WFF
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
TenTec Info Page -
Contesting<http://lists.contesting.com/mailman/listinfo/tentec>
lists.contesting.com
Welcome to the Ten-Tec mailing list! This list is intended for the exchange of
information on Ten-Tec-related topics ONLY. Off Topic subject postings should
be ...
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|