| To: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
|---|---|
| Subject: | Re: [TenTec] [Ten Tec} Corsair II weak weak receive |
| From: | Steve Hunt <steve@karinya.net> |
| Reply-to: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
| Date: | Tue, 20 Oct 2015 09:32:12 +0100 |
| List-post: | <tentec@contesting.com">mailto:tentec@contesting.com> |
The first thing I'd do is check that R33 is not open-circuit, or has
become disconnected at one end or the other.
Steve G3TXQ On 19/10/2015 22:40, jon greenwood via TenTec wrote: Update on Corsair: replaced all the pin diodes. Before putting Q6 back tested voltages again per Steve's suggestion. Still reading 11.52V at both points Steve suggested to measure. Have not reinstalled Q6. Can't figure out what is causing the high voltage readings.???Jon _______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.contesting.com/mailman/listinfo/tentec |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: [TenTec] Open Wire Line 1 Wavelength dipole, Rick - DJ0IP / NJ0IP |
|---|---|
| Next by Date: | Re: [TenTec] Open Wire Line - A CASE FOR OCFD, Rick - DJ0IP / NJ0IP |
| Previous by Thread: | Re: [TenTec] [Ten Tec} Corsair II weak weak receive, jon greenwood via TenTec |
| Next by Thread: | Re: [TenTec] [Ten Tec} Corsair II weak weak receive, jon greenwood via TenTec |
| Indexes: | [Date] [Thread] [Top] [All Lists] |