Update on Corsair: replaced all the pin diodes. Before putting Q6 back tested
voltages again per Steve's suggestion. Still reading 11.52V at both points
Steve suggested to measure. Have not reinstalled Q6. Can't figure out what is
causing the high voltage readings.???Jon
On Sunday, October 11, 2015 1:33 AM, Steve Hunt <steve@karinya.net> wrote:
Jon,
One other check you might want to make while Q6 is removed: on Rx,
measure the voltage at the R32/R33 junction, and the voltage at the
R31/R32 junction; they should be around 1.7v and 9.5v respectively.
Steve G3TXQ
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|