I have had this problem since day one and two trips to TT resulted in only a
temporary fix. The problem always returned.
As of the writing of this mail, the sub rcvr has been inop for a couple of
years - no plan to return to the factory.
I have heard all of the war stories about intermittent pins/ribbon cables,
encoders and that is not the problem. My suspect is the "audio switch"
circuit but can not remember on which board it is located.
Mike
W8TRN
----- Original Message -----
From: "denton sprague" <denton@oregontrail.net>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Sunday, October 11, 2015 11:01
Subject: [TenTec] Orion sub receiver getting no signals
Hi all…my trusty Orion that came back from TT for processor board
replacement a few months ago seems to have no receive signals…this happened
this am when booting up the rig.
I use ant 1 as main rx/tx as well as sub rx.
I can hear the sub noise come up when pressing the sub rx button, but
evidently getting no signals from the antenna.
I have only one hf antenna.
Did a master reset to no avail.
loose cable maybe??
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|