I will get back home on Feb 22 and I will test it out then to see if I
can reproduce your results. But does this happen if you don't use the
frequency scale slider and instead use the band buttons to change frequency.
Carl Moreschi N4PY
58 Hogwood Rd
Louisburg, NC 27549
www.n4py.com
On 2/15/2015 9:04 PM, David Perrin wrote:
Hi-
I have my older EAGLE connected to my Toshiba notebook (no serial
ports) with a USB cable and the COM (UART) is at com12. I get pretty good
communication between the computer and the EAGLE, but one problem persists.
The software misses the frequency of the EAGLE by 1.5MHz. Many times I have
set the frequency of the EAGLE to 10MHz and the software to 10MHz, and I have fine
tuned both to get the same pitch on both USB and LSB, I have set A=B to both
VFO’s, I have run the Calibrate routine. It all looks the same on the software
and the EAGLE.
As soon as I try to change the frequency of the software by sliding the
tuner dial the EAGLE jumps frequency by 1.5 MHz to 8.5MHz.
What is up with that? Any ideas?
73 de Dave, K1OPQ/4
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|