My apologies if this is a repeat:
> Begin forwarded message:
>
> Subject: EAGLE and N4PY software issue
> From: David Perrin <dbperrin@gmail.com>
> Date: February 15, 2015 at 9:04:21 PM EST
> To: Tentec reflector <tentec@contesting.com>
>
> Hi-
> I have my older EAGLE connected to my Toshiba notebook (no serial
> ports) with a USB cable and the COM (UART) is at com12. I get pretty good
> communication between the computer and the EAGLE, but one problem persists.
> The software misses the frequency of the EAGLE by 1.5MHz. Many times I
> have set the frequency of the EAGLE to 10MHz and the software to 10MHz, and I
> have fine tuned both to get the same pitch on both USB and LSB, I have A=B to
> both VFO’s, I have run the Calibrate routine. It all looks the same on the
> software and the EAGLE.
> As soon as I try to change the frequency of the software by sliding the
> tuner dial the EAGLE jumps frequency by 1.5 MHz to 8.5MHz.
> What is up with that? Any ideas?
>
> 73 de Dave, K1OPQ/4
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|