Hi-
I have my older EAGLE connected to my Toshiba notebook (no serial
ports) with a USB cable and the COM (UART) is at com12. I get pretty good
communication between the computer and the EAGLE, but one problem persists.
The software misses the frequency of the EAGLE by 1.5MHz. Many times I
have set the frequency of the EAGLE to 10MHz and the software to 10MHz, and I
have fine tuned both to get the same pitch on both USB and LSB, I have set A=B
to both VFO’s, I have run the Calibrate routine. It all looks the same on the
software and the EAGLE.
As soon as I try to change the frequency of the software by sliding the
tuner dial the EAGLE jumps frequency by 1.5 MHz to 8.5MHz.
What is up with that? Any ideas?
73 de Dave, K1OPQ/4
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|