Is this a DS-1220Y or -1220AP IC?
Kim N5OP
"People that make music together cannot be enemies, at least as long as the
music lasts." -- Paul Hindemith
> On Feb 11, 2015, at 8:49, Peter Bertini <radioconnection@gmail.com> wrote:
>
> Well, I had a few opened up, but it is not a "chip," but a chip encased in
> a plastic case on a DIP header. The IC inside does have a pin for the
> external battery, but in the module the pin is bent back 180 degrees and
> does not exit the header. The battery is internal, and soldered directly to
> the pins of the IC.
>
> Yes, it is possible, with some skill and patience, to open the part, dig
> away at the filler, and expose the IC--the device could be modified to use
> an external lithium batter in a holder, and the radio would also need some
> minor mods.
>
> As I recall, this part, which is a Dallas Time Chip with internal ram, is
> soldered to the board in the Paragon II. I added a socket, which is NOT an
> approved modification according to the TenTec factory.
>
> I could provide some photos, but my guinea pigs are lost in the morass of
> my unkempt shop. I figured I'd cross that bridge when the chips were no
> longer available. My CAT-1000 repeater controller uses a similar Dallas
> Time chip for date, time and to store controller parameters.
>
> regards
>
> Pete, KIZJH
>
> I just did a quick Google, and found that this is not uncharted territory:
>
> http://www.classic-computers.org.nz/blog/2009-10-10-renovating-a-dallas-battery-chip.htm
>
>
> *O.K. I will be the first one to ask. Has nobody figured out yet where the
> positive and negative battery terminals are on this RAM Chip? Maybe I have
> just ask the Stupidest Question, ever ask on this forum. I have never seen
> one of these RAM Chips. Can somebody please send me a picture of an example
> Chip? It just seems to me that some fine wire leads and a battery holder
> with the correct voltage of batteries installed, could place an end to the
> whole problem. Aw Shucks, you could even install a small solar cell
> illuminated from an Ironman or Batman 7 watt nightlight ..... hi .. hi ...
> This is a good question ( I Hope ) Maybe the Internal Battery shorts to
> Zero Ohms? So that an outboard battery won't work? *
> * As Johnny 5 Says .... Need Input !! 73 from Wade/KJ4WS*
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|