Just to check - Carl, you're not referring to the Omni V chip discussed on
another thread?
Barry N1EU
On Wed, Feb 11, 2015 at 3:13 PM, Carl Moreschi <n4py3@earthlink.net> wrote:
> It's not the EPROM chip. There's no burning. It's a RAM chip with a
> built in battery.
>
> Carl Moreschi N4PY
> 58 Hogwood Rd
> Louisburg, NC 27549
> www.n4py.com
>
>
> On 2/11/2015 8:54 AM, Clayton Brantley via TenTec wrote:
>
>> I would talk with Gary at TenTec. They have a few oldies that they could
>> pull a epromor perhaps burn another one.
>>
>> Clayton N4EV
>>
>> From: Barry N1EU<barry.n1eu@gmail.com>
>> To: Discussion of Ten-Tec Equipment<tentec@contesting.com>
>> Sent: Tuesday, February 10, 2015 8:31 AM
>> Subject: Re: [TenTec] WTB: part from junker Omni VI option 1 rig
>>
>> Have you tried calling Ten-Tec for the chip?
>>
>> Barry N1EU
>>
>> On Tue, Feb 10, 2015 at 8:29 AM, Peter Bertini<radioconnection@gmail.com>
>> wrote:
>>
>> If anyone is parting out an Omni VI with the option 1 installed, I'd be
>>> interested in buying the complete board and or just the upgrade chip.
>>>
>>> Not being able to individually lock A and B VFOs is a pain when chasing
>>> split operations.
>>>
>>> Pete
>>> _______________________________________________
>>> TenTec mailing list
>>> TenTec@contesting.com
>>> http://lists.contesting.com/mailman/listinfo/tentec
>>>
>>
>>
>>
>>> _______________________________________________
>> TenTec mailing list
>> TenTec@contesting.com
>> http://lists.contesting.com/mailman/listinfo/tentec
>>
>>
>>
>> _______________________________________________
>> TenTec mailing list
>> TenTec@contesting.com
>> http://lists.contesting.com/mailman/listinfo/tentec
>>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|