| To: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
|---|---|
| Subject: | Re: [TenTec] WTB: part from junker Omni VI option 1 rig |
| From: | Clayton Brantley via TenTec <tentec@contesting.com> |
| Reply-to: | Clayton Brantley <clayton_n4ev@yahoo.com>, Discussion of Ten-Tec Equipment <tentec@contesting.com> |
| Date: | Wed, 11 Feb 2015 14:01:21 +0000 (UTC) |
| List-post: | <tentec@contesting.com">mailto:tentec@contesting.com> |
I have a logic board from an option 3. It was working when the rig wasparted
out. Think the chips are the same. Has the 564 DSP chip too. Thiswould mean
that you might have to change a few of the pushbutton legends.
Clayton N4EV
From: Peter Bertini <radioconnection@gmail.com>
To: "tentec@contesting.com" <tentec@contesting.com>
Sent: Tuesday, February 10, 2015 11:58 AM
Subject: Re: [TenTec] WTB: part from junker Omni VI option 1 rig
NOT available. Just checked.
Pete
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: [TenTec] WTB: part from junker Omni VI option 1 rig, Clayton Brantley via TenTec |
|---|---|
| Next by Date: | Re: [TenTec] OMNI 5 GOES DEAD ON 40, Peter Bertini |
| Previous by Thread: | Re: [TenTec] WTB: part from junker Omni VI option 1 rig, Peter Bertini |
| Next by Thread: | Re: [TenTec] WTB: part from junker Omni VI option 1 rig, Peter Bertini |
| Indexes: | [Date] [Thread] [Top] [All Lists] |