I am not a cable expert, but I did own a T-T OMNI VI+. I no longer own it or
have the manual. I do remember building my own cable.
This should help:
http://www.tentec.com/pages/Trouble-shooting-the-Omni%252dVI%252b-serial-int
erface-.html
For the ultimate authority on this talk to Paul Clinton at T-T.
73,
Marsh, KA5M
-----Original Message-----
From: TenTec [mailto:tentec-bounces@contesting.com] On Behalf Of Allan
Taylor
Sent: Monday, February 02, 2015 9:46 AM
To: tentec@contesting.com
Subject: [TenTec] 'serial' cable for OmniVI/VI+
At one time, I had the interface cable for my OmniVIs. It apparently is
lost in
a shack reorg. Going back to my old manual, I have comments to the effect
that the schematic/sketch is in error and that the connections are 2-3 and
3-2
rather than straight through. This is all familiar to me. There is also a
jumper
between two terminals on the 9-pin end.
My question for the cable experts is this: is there a stock cable out there
that
works with the OmniVI or do I need to manufacture one?
NO guesses, please. I need the real story...
--
73 Allan K7GT
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|