Allan....
I currently have my OmniVI+ communicating just fine with several programs.
I use an off-the-shelf serial to USB adapter.
...Dave
On 2/2/15 10:46 AM, Allan Taylor wrote:
At one time, I had the interface cable for my OmniVIs. It apparently is
lost in
a shack reorg. Going back to my old manual, I have comments to the effect
that the schematic/sketch is in error and that the connections are 2-3 and
3-2
rather than straight through. This is all familiar to me. There is also a
jumper
between two terminals on the 9-pin end.
My question for the cable experts is this: is there a stock cable out there
that
works with the OmniVI or do I need to manufacture one?
NO guesses, please. I need the real story...
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|