Allan: I am using the TenTec USB cable with my Omni VI+ along with CQRlog
running under Linux. Worksgreat! I had all kinds of problems with Windo$$$,
but Linux came up and ran with it. Didn't have to worryabout drivers or
anything else. Dumped the MS product and installed Unbuntu Linux then added
CQRlog.
73 Clayton N4EV
From: Dave Edwards <kd2e@comcast.net>
To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Sent: Monday, February 2, 2015 10:51 AM
Subject: Re: [TenTec] 'serial' cable for OmniVI/VI+
Allan....
I currently have my OmniVI+ communicating just fine with several programs.
I use an off-the-shelf serial to USB adapter.
...Dave
On 2/2/15 10:46 AM, Allan Taylor wrote:
> At one time, I had the interface cable for my OmniVIs. It apparently is
> lost in
> a shack reorg. Going back to my old manual, I have comments to the effect
> that the schematic/sketch is in error and that the connections are 2-3 and
> 3-2
> rather than straight through. This is all familiar to me. There is also a
> jumper
> between two terminals on the 9-pin end.
>
> My question for the cable experts is this: is there a stock cable out there
> that
> works with the OmniVI or do I need to manufacture one?
>
> NO guesses, please. I need the real story...
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|