Re: [TenTec] Eagle 9MHz tap questions.

[Carl Moreschi <n4py3@earthlink.net>]

You can add a panadapter to the Eagle without adding the 9 mhz IF.  I 
did it with my Eagle.  I replaced cable #2 with a Y cable.  The third 
peg of the Y cable then goes to a panadapter receiver.  This is very 
similar to the Omni VII mod and works great.  You then connect the third 
leg of the Y cable to a Softrock Ensemble II or other panadapter radio.
Carl Moreschi N4PY
58 Hogwood Rd
Louisburg, NC 27549
www.n4py.com

On 12/22/2014 11:32 PM, Rick - DJ0IP / NJ0IP wrote:
> I was wanting to add a pan-adapter.
> I may have to replace a board in order to do that.
> My unit does not have the TMP jack with the 9 MHz out.
>
> Also I have to find a way to run the signal out the back.
> I already have two spare RCA Phono jacks in use for the pre-selector.
>
> 73 - Rick, DJ0IP
> (Nr. Frankfurt am Main)
>
> -----Original Message-----
> From: TenTec [mailto:tentec-bounces@contesting.com] On Behalf Of Richards
> Sent: Tuesday, December 23, 2014 2:49 AM
> To: Discussion of Ten-Tec Equipment
> Subject: Re: [TenTec] Eagle 9MHz tap questions.
>
> Are you going to add a panadapter ?
>
> ================== K8JHR ==================
>
>
> On 12/22/2014 2:46 PM, Rick - DJ0IP / NJ0IP wrote:
> > Is it just a tap, like perhaps a Y-connection, or does it also have a
> buffer stage?
> > Unfortunately my Eagle fell out of the nest before that feature was added
> to the radio.
> > ____________________________________________
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec