-----Izvorna poruka-----
From: Rick - DJ0IP / NJ0IP
Sent: Tuesday, December 23, 2014 5:32 AM
To: 'Discussion of Ten-Tec Equipment'
Subject: Re: [TenTec] Eagle 9MHz tap questions.
I was wanting to add a pan-adapter.
I may have to replace a board in order to do that.
My unit does not have the TMP jack with the 9 MHz out.
Also I have to find a way to run the signal out the back.
I already have two spare RCA Phono jacks in use for the pre-selector.
73 - Rick, DJ0IP
(Nr. Frankfurt am Main)
-----Original Message-----
From: TenTec [mailto:tentec-bounces@contesting.com] On Behalf Of Richards
Sent: Tuesday, December 23, 2014 2:49 AM
To: Discussion of Ten-Tec Equipment
Subject: Re: [TenTec] Eagle 9MHz tap questions.
Are you going to add a panadapter ?
================== K8JHR ==================
On 12/22/2014 2:46 PM, Rick - DJ0IP / NJ0IP wrote:
Is it just a tap, like perhaps a Y-connection, or does it also have a
buffer stage?
Unfortunately my Eagle fell out of the nest before that feature was added
to the radio.
____________________________________________
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|