TenTec
[Top] [All Lists]

Re: [TenTec] Eagle 9MHz tap questions.

To: "R. Eric Sluder-W9WLW" <resluder@yahoo.com>, Discussion of Ten-Tec Equipment <tentec@contesting.com>
Subject: Re: [TenTec] Eagle 9MHz tap questions.
From: Barry N1EU <barry.n1eu@gmail.com>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Mon, 22 Dec 2014 14:35:28 -0500
List-post: <tentec@contesting.com">mailto:tentec@contesting.com>
I think it's likely that updated schematics were not published.  Bob, what
are you hoping to do with the 9MHz i.f. output?

Barry N1EU

On Mon, Dec 22, 2014 at 1:44 PM, R. Eric Sluder-W9WLW via TenTec <
tentec@contesting.com> wrote:

> It is after the mixer and before the roofing filter.  I don't have the
> schematics handy where I am at, but I do recall it between those two
> segments.  I'll be back in my shack later tonight and can look at
> schematics then.
> 73 -EricW9WLW
>
>       From: Katz Ajamas <ajamas.rn@gmail.com>
>  To: tentec@contesting.com
>  Sent: Monday, December 22, 2014 1:17 PM
>  Subject: Re: [TenTec] Eagle 9MHz tap questions.
>
> Eric-
>
> I've carefully gone over the schematics and can not find the tap. They are
> dated 2010 and I can not find any revision notes either. I will really
> appreciate it if you can tell me where the 9MHz tap is located. To be
> clear, I am not talking about the modification to add a second receiver
> that is added after the low pass filters. The 9MHz tap should be somewhere
> after the first mixer and before the second mixer. I just don't see it on
> the schematics from the tentec web site.
>
> 73,
> -Bob
>
>
>
> > Message: 1
> > Date: Sun, 21 Dec 2014 13:23:33 -0500
> > From: "R. Eric Sluder via TenTec" <tentec@contesting.com>
> > To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
> > Subject: Re: [TenTec] Eagle 9MHz tap questions.
> > Message-ID: <5227AC58-CE90-4CC7-B482-2398FB193DA1@yahoo.com>
> > Content-Type: text/plain;      charset=utf-8
> >
> > Bob,
> >
> > I am in the "man cave" watching football and cannot answer your question
> > directly; the schematics are online at TT and that is where I found the
> tap.
> >
> > 73
> >
> > -Eric
> > W9WLW
> >
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>