Carl, what is required software for this SDR Project? I am using your
software with an Eagle. Will it interface with the Smartrock hardware?
Thanks,
Bill, AK5K
-----Original Message-----
From: TenTec [mailto:tentec-bounces@contesting.com] On Behalf Of Carl
Moreschi
Sent: Wednesday, November 05, 2014 11:21 AM
To: Don Rasmussen; Discussion of Ten-Tec Equipment
Subject: [Bulk] Re: [TenTec] OT: Holiday SDR Project
That will work well for you. My N4PY software can provide everything you
need to keep the softrock and your transceiver on the same frequency.
Carl Moreschi N4PY
58 Hogwood Rd
Louisburg, NC 27549
www.n4py.com
On 11/5/2014 11:34 AM, Don Rasmussen via TenTec wrote:
After all this talk about the new Flex Series and peripherals it seems all
of my objections have melted away except for the oldest one - cost! Flex
6300 with FX-PAD and TMate2 are outside of my ham radio budget but only
because I have that amount of money tied up in existing gear that I enjoy.
I did decide to take a look at what Tony Parks has been up to and found a
very inexpensive SDR project for the holidays. I can enjoy the build and
then mess with the software. The 1.8-30Mhz receiver is $68 and the option
cabinet is $20.
http://tinyurl.com/qx4ha8p
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec