That will work well for you. My N4PY software can provide everything
you need to keep the softrock and your transceiver on the same frequency.
Carl Moreschi N4PY
58 Hogwood Rd
Louisburg, NC 27549
www.n4py.com
On 11/5/2014 11:34 AM, Don Rasmussen via TenTec wrote:
After all this talk about the new Flex Series and peripherals it seems all of
my objections have melted away except for the oldest one - cost! Flex 6300 with
FX-PAD and TMate2 are outside of my ham radio budget but only because I have
that amount of money tied up in existing gear that I enjoy.
I did decide to take a look at what Tony Parks has been up to and found a very
inexpensive SDR project for the holidays. I can enjoy the build and then mess
with the software. The 1.8-30Mhz receiver is $68 and the option cabinet is $20.
http://tinyurl.com/qx4ha8p
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|