TenTec
[Top] [All Lists]
<prev [Date] next>
[Advanced]
 <prev [Thread] next>

Re: [TenTec] din connector, etc.

from [Jim Brown] [Permanent Link][Original]
To: tentec@contesting.com
Subject: Re: [TenTec] din connector, etc.
From: Jim Brown <k9yc@audiosystemsgroup.com>
Reply-to: k9yc@arrl.net, Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Wed, 24 Sep 2014 16:50:42 -0700
List-post: <tentec@contesting.com">mailto:tentec@contesting.com> 
On Wed,9/24/2014 4:45 PM, Bob McGraw - K4TAX wrote:
It does not shorten the dit. From key closure, it delays it by ~17ms from start to finish.
That would be fine if it works that way, but it does not with most rigs. Have either of you verified that it does (with a dual trace scope)? 

73, Jim K9YC

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
[More with this subject...]
<Prev in Thread] Current Thread [Next in Thread>
Previous by Date:  Re: [TenTec] din connector, etc., Bob McGraw - K4TAX
Next by Date:  Re: [TenTec] din connector, etc., Bob McGraw - K4TAX
Previous by Thread:  Re: [TenTec] din connector, etc., Bob McGraw - K4TAX
Next by Thread:  Re: [TenTec] din connector, etc., Bob McGraw - K4TAX
Indexes:  [Date] [Thread] [Top] [All Lists]