To: | Clayton Brantley <clayton_n4ev@yahoo.com>, Discussion of Ten-Tec Equipment <tentec@contesting.com> |
---|---|
Subject: | Re: [TenTec] Omni VI+, 422 and 253? |
From: | Cecil <chacuff@cableone.net> |
Reply-to: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
Date: | Sat, 15 Mar 2014 09:07:33 -0500 |
List-post: | <tentec@contesting.com">mailto:tentec@contesting.com> |
Sent from my iPad On Mar 15, 2014, at 7:42 AM, Clayton Brantley <clayton_n4ev@yahoo.com> wrote: > > > They are the same as far as the electronics go, but you may not advertize a > 563 rev 3 > as a VI+. The only differences are the front and rear panels BUT one is a > 563 and the > other is a 564. > > >> >> _______________________________________________ >> Thanks you made my point... Don't care what the model number is, technically...electronically they are the same, and the discussion was centered around interfacing to the radio where that is all that mattered. 73 Cecil K5DL _______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.contesting.com/mailman/listinfo/tentec |
<Prev in Thread] | Current Thread | [Next in Thread> |
---|---|---|
|
Previous by Date: | Re: [TenTec] Omni VI+, 422 and 253?, Clayton Brantley |
---|---|
Next by Date: | Re: [TenTec] Omni VI+, 422 and 253?, Timothy Johnston |
Previous by Thread: | Re: [TenTec] Omni VI+, 422 and 253?, Clayton Brantley |
Next by Thread: | Re: [TenTec] Omni VI+, 422 and 253?, Jim Lowman |
Indexes: | [Date] [Thread] [Top] [All Lists] |