John, just to be clear about my deja vu - you posted the same question on
October 2 and got the same answer.
http://lists.contesting.com/archives//html/TenTec/2013-10/msg00028.html
73, Barry N1EU
On Thu, Oct 10, 2013 at 5:48 PM, JOHN <ku3g@yahoo.com> wrote:
> john , thanks icalled tentec spoke to the gentleman that repairs the omni
> 6 and he told me althought hewasnt familar with the n3fjp software that
> uyou must key the rig thru the key port , i'm one of those guys who never
> throws anything away so i must have the interface somewhere, thanks very
> much john and 73
> john ku3g
> --------------------------------------------
> On Thu, 10/10/13, John Huffman <hjohnc@gmail.com> wrote:
>
> Subject: Re: [TenTec] omni 6
> To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
> Date: Thursday, October 10, 2013, 10:21 AM
>
> John -
>
> You need a separate serial cable with nan interface on the
> rig end to
> send CW. There are sample circuits on the N3FJP web
> site.
>
> 73 de K1ESE
> John
>
>
> On 10/10/2013 10:06 AM, JOHN wrote:
> > good morning gang
> > I have an omni 6 runing n3fjp
> softwave , i am using a w1gee interface from the computer to
> the ci/v jack on the rear of the omni , control of the rig
> is fine, however i can not send cw , i am almost 99% sure i
> did this in the past , any ideas would be appreciated
> > 73 john ku3g
> > _______________________________________________
> > TenTec mailing list
> > TenTec@contesting.com
> > http://lists.contesting.com/mailman/listinfo/tentec
> >
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|