TenTec
[Top] [All Lists]

Re: [TenTec] omni 6

To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Subject: Re: [TenTec] omni 6
From: JOHN <ku3g@yahoo.com>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Thu, 10 Oct 2013 10:48:35 -0700 (PDT)
List-post: <tentec@contesting.com">mailto:tentec@contesting.com>
john , thanks  icalled tentec spoke to the gentleman that repairs the omni 6 
and he told me althought hewasnt familar with the n3fjp software that uyou must 
key the rig thru the key port , i'm one of those guys who never throws anything 
away so i must have the interface somewhere, thanks very much john and 73
john ku3g
--------------------------------------------
On Thu, 10/10/13, John Huffman <hjohnc@gmail.com> wrote:

 Subject: Re: [TenTec] omni 6
 To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
 Date: Thursday, October 10, 2013, 10:21 AM
 
 John -
 
 You need a separate serial cable with nan interface on the
 rig end to 
 send CW.  There are sample circuits on the N3FJP web
 site.
 
 73 de K1ESE
 John
 
 
 On 10/10/2013 10:06 AM, JOHN wrote:
 > good morning gang
 >     I have an omni 6 runing n3fjp
 softwave , i am using a w1gee interface from the computer to
 the ci/v jack on the rear of the omni , control of the rig
 is fine, however i can not send cw , i am almost 99% sure i
 did this in the past , any ideas would be appreciated
 > 73 john ku3g
 > _______________________________________________
 > TenTec mailing list
 > TenTec@contesting.com
 > http://lists.contesting.com/mailman/listinfo/tentec
 >
 
 _______________________________________________
 TenTec mailing list
 TenTec@contesting.com
 http://lists.contesting.com/mailman/listinfo/tentec
 
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>