Roger,
I'm sure there are a lot of guys here with a lot more knowledge on the
Corsair than me.
I was just making a comment in general about how ten-tec built all of their
analog radios.
If you slip one pin on the plug, you blow out the T/R switching voltage.
I personally have never even seen a Corsair.
I've owned most Ten-Tec radios, except the Corsair, Pegasis, and Paragon.
73
Rick, DJ0IP
-----Original Message-----
From: TenTec [mailto:tentec-bounces@contesting.com] On Behalf Of Roger C.
Rose
Sent: Thursday, October 10, 2013 2:54 AM
To: tentec@contesting.com
Subject: Re: [TenTec] Corsair 560 connectors (Rick - DJ0IP / NJ0IP)
Rick, thanks for your thoughts. The connector I offset was 53 on the control
board. I'm not sure which way so I don't really know where to look. I tried
tracing the leads and had a hard time because of how their prints are laid
out. Most of the leads go to the accessory socket but others go off to
points unknown (to me, at least) on the main chassis print. I have a PDF of
the manual and if you feel like giving me a hand with it, I'd really
appreciate it.
73, Roger W5LXS
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|