John
I use Astron RSM 35 with all my solid state radios including OMNI VI
Very good supply with overvoltage and over current protection
Paul
--------------------------------------------------
From: "John Farler" <k4avx1@windstream.net>
Sent: Tuesday, August 27, 2013 3:21 PM
To: <tentec@contesting.com>
Subject: [TenTec] Using Non-TT Supply
My supply for the TT Omni V or VI has problems. When I tune up, even to
a dummy load,
the pilots in the radio dim and output is not where it should be on 40
meters and up.
Current is less than 20 A, but I haven't checked the voltage drop yet.
My question is can I use a non-TT supply with the Omni VI safely? I
remember someone
on the list saying TT stopped using the original type of power supply
like the one with
the old Triton which kicks of at a certain current, but I can't remember
which radio it
is that doesn't depend on the "circuit breaker" type of protection.
I have several non-TT supplies that will provide the current and more -
is it safe to use
them with the Omni V, VI??
I'm guessing the filters in the power supply have gone bad...actually it
has 3 in parallel.
How can I check for one bad one, or can I?
Thanks, and I hope my post is not too confusing....
John, K4AVX
k4avx1@windstream.net
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|