TenTec
[Top] [All Lists]

Re: [TenTec] Orion trim pot adjustment

To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Subject: Re: [TenTec] Orion trim pot adjustment
From: Carl Moreschi <n4py3@earthlink.net>
Reply-to: n4py3@earthlink.net, Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Sun, 26 May 2013 11:25:36 -0400
List-post: <tentec@contesting.com">mailto:tentec@contesting.com>
Make sure the radio is warm and at normal operating temperature when you do this because this will vary a little with temperature. I was able to get my Orion within a few hertz of actual frequency by doing this.

Carl Moreschi N4PY
121 Little Bell Dr.
Hays, NC 28635
www.n4py.com

On 5/26/2013 11:10 AM, Barry N1EU wrote:
Can anybody tell me what Orion adjustment is controlled by the trim pot
that is accessible through the hole in the top directly behind the front
panel (in line with "audio" button"), with the top cover removed?

Thanks&  73,
Barry N1EU
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>