TenTec
[Top] [All Lists]

Re: [TenTec] OrionII and MixW Config settings

To: Ten-Tec Reflector <tentec@contesting.com>
Subject: Re: [TenTec] OrionII and MixW Config settings
From: Rick W <ve7tk@yahoo.ca>
Reply-to: Rick W <ve7tk@yahoo.ca>, Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Thu, 15 Nov 2012 10:06:48 -0800 (PST)
List-post: <tentec@contesting.com">mailto:tentec@contesting.com>
The AUX cable does NOT bring out the FSK output that you need.  You will need 
to build an new cable or purchase one.  This issue was discussed earlier on:

http://lists.contesting.com/archives//html/TenTec/2012-10/msg00134.html


You can do AFSK with the stock cable but not FSK.
 
73,
Rick
VE7TK


Website:  http://www.ve7tk.com

To:"Discussion of Ten-Tec Equipment" <tentec@contesting.com> 
Subject:[TenTec] OrionII and MixW Config settings 
From:"EI6DL" <ei6dl@eircom.net> 
Reply-to:Discussion of Ten-Tec Equipment <tentec@contesting.com> 
Date:Wed, 14 Nov 2012 21:13:34 -0000 
List-post:<tentec@contesting.com">mailto:tentec@contesting.com> 
Hello ! I have just connected the TenTec Model 712 USB to the Aux/I on my Orion 
II and ran MixW on my PC .The programme is reading the Digi fsk signals ok but 
i can not get the programme configed to transmit /send a sig I have the 
programme set for the TenTec Orion II and have gone into the menu on the Orion 
II and changed the TX Audio source to Aux instead Mic.Still will not force the 
transciever to TX a digi sig ?? Can anyone help ? 73'es Tony EI6DL 
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>