TenTec
[Top] [All Lists]

Re: [TenTec] Omni V filter lights don't correspond with the filters

To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Subject: Re: [TenTec] Omni V filter lights don't correspond with the filters
From: Clayton Brantley <clayton_n4ev@yahoo.com>
Reply-to: Clayton Brantley <clayton_n4ev@yahoo.com>, Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Thu, 1 Nov 2012 16:48:20 -0700 (PDT)
List-post: <tentec@contesting.com">mailto:tentec@contesting.com>
Bob:  Same thing happened here on my Omni VI+.  The logic board has 3 pins and
two on the cable.  I had put the plug on the wrong two pins.  Just moved it 
over one
pin and it worked right!

Clayton N4EV




________________________________
 From: Bob Towers <mm0rkt@gmx.com>
To: tentec@contesting.com 
Sent: Thursday, November 1, 2012 2:28 PM
Subject: [TenTec] Omni V filter lights don't correspond with the filters
 
Some time ago I replaced the main tuning digital encoder which was faulty.

It involved taking off the front panel and removing all the connectors at the 
back of it. I put it all back together and I then noticed that each filter 
indicator light didn't correspond with the appropriate IF filter. I had 
obviously put one of the connectors back wrongly. If I remember right, the 
connector on the front panel had 3 pins and the matching lead, 2 sockets.

The time has come to do something about it but for the life of me I can't 
remember which connector it was. Can anyone help?

Many thanks and 73

Bob Towers
MM0RKT

(for the reflector moderator: apologies for the previous copy of this email, 
sent from the wrong email address!)
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>