TenTec
[Top] [All Lists]

Re: [TenTec] Omni V filter lights don't correspond with the filters

To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Subject: Re: [TenTec] Omni V filter lights don't correspond with the filters
From: "Robert Mcgraw" <rmcgraw@blomand.net>
Reply-to: rmcgraw@blomand.net, Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Thu, 1 Nov 2012 14:22:51 -0500 (CDT)
List-post: <tentec@contesting.com">mailto:tentec@contesting.com>
Unless they have fallen off, usually there is a small white label with a
number on it on the cable connector and the respective connector on the
PCB.  Match them up.  And If you have a manual, the connectors are
numbered as well.  Unfortunately, I don't recall being a pictorial.

73
Bob, K4TAX



> Some time ago I replaced the main tuning digital encoder which was
> faulty.
>
> It involved taking off the front panel and removing all the connectors
> at the back of it. I put it all back together and I then noticed that
> each filter indicator light didn't correspond with the appropriate IF
> filter. I had obviously put one of the connectors back wrongly. If I
> remember right, the connector on the front panel had 3 pins and the
> matching lead, 2 sockets.
>
> The time has come to do something about it but for the life of me I
> can't remember which connector it was. Can anyone help?
>
> Many thanks and 73
>
> Bob Towers
> MM0RKT
>
> (for the reflector moderator: apologies for the previous copy of this
> email, sent from the wrong email address!)
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>


_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>