Some time ago I replaced the main tuning digital encoder which was faulty.
It involved taking off the front panel and removing all the connectors
at the back of it. I put it all back together and I then noticed that
each filter indicator light didn't correspond with the appropriate IF
filter. I had obviously put one of the connectors back wrongly. If I
remember right, the connector on the front panel had 3 pins and the
matching lead, 2 sockets.
The time has come to do something about it but for the life of me I
can't remember which connector it was. Can anyone help?
Many thanks and 73
Bob Towers
MM0RKT
(for the reflector moderator: apologies for the previous copy of this
email, sent from the wrong email address!)
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|