Good deal. Glad you found the problem.
----- Original Message -----
From: "Don Rasmussen" <wb8yqj@yahoo.com>
To: <tentec@contesting.com>
Sent: Friday, March 30, 2012 2:34 PM
Subject: [TenTec] OMNI VI+ found 12m
Ten Tec had the crystal for 12m, what a blessing, but it turns out I did not
need it, the 12m crystal is located closest to one of the board mounting
holes. The side of the crystal closest to the hole had broken at the solder
connection. It works FB now after resoldering it.
--- On Sun, 3/25/12, Don Rasmussen <wb8yqj@yahoo.com> wrote:
From: Don Rasmussen <wb8yqj@yahoo.com>
Subject: Re: OMNI VI+ lost 12m
To: tentec@contesting.com
Date: Sunday, March 25, 2012, 9:13 AM
Thanks Rick, I can probably cheat and set an external receiver w/probe at
the crystal frequency, probably the next course of action.
Re: [TenTec] OMNI VI+ lost 12m
from [Rick - DJ0IP / NJ0IP] [Permanent Link][Original]
Don,
This is another case where a scope would be a real blessing.
You would see in a few seconds whether or not the oscillator were
functioning.
73
Rick, DJ0IP
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|