But the s-meter should follow the audio if it's a relay issue, ja?
73,
Barry N1EU
On Tue, Mar 20, 2012 at 8:35 PM, Rick - DJ0IP / NJ0IP <Rick@dj0ip.de> wrote:
> Paul, do you happen to have a linear amplifier connected?
>
> What you are describing is EXACTLY the condition one can have if the T/R
> relay contacts on the amplifier's relay are a little burnt.
> If that is the case, cleaning the relay with a burnishing tool will fix the
> problem.
>
> 73
> Rick, DJ0IP
>
> -----Original Message-----
> From: tentec-bounces@contesting.com [mailto:tentec-bounces@contesting.com]
> On Behalf Of Paul Kraemer
> Sent: Tuesday, March 20, 2012 8:18 PM
> To: Discussion of Ten-Tec Equipment
> Subject: [TenTec] 564
>
> Radio is "new" to me and so far a nice performer
>
> Two glitches I observe:
> (1) Sometimes, more often than not, when I turn on power the S meter is
> active indicating signals but the audio is mute for some delay, varies from
> fraction of second to seconds
> (2) During a recent ssb QSO the receive would not always come back to level
> it was before transmitting. Keying the PTT will bring it back.
>
> Any suggestions or "yeah it does that" always appreciated
>
> Paul K0UYA
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|