Paul, all I can offer is that it is NOT normal. It almost seems like a
sticky relay but if that was the case then the s-meter wouldn't show
signal.
If the s-meter shows signal and you don't hear any audio, things I would
suspect are the AF section and AF connections on the IF/AF board or in the
dsp loop/dsp control logic.
Barry N1EU
On Tue, Mar 20, 2012 at 7:17 PM, Paul Kraemer <elespe@lisco.com> wrote:
> Radio is "new" to me and so far a nice performer
>
> Two glitches I observe:
> (1) Sometimes, more often than not, when I turn on power the S meter is
> active indicating signals but the audio is mute for some delay, varies from
> fraction of second to seconds
> (2) During a recent ssb QSO the receive would not always come back to level
> it was before transmitting. Keying the PTT will bring it back.
>
> Any suggestions or "yeah it does that" always appreciated
>
> Paul K0UYA
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|