Let me see if I understand this function. I would select an S meter
value (say S9) then change the digital count so that the S meter reads
S9. Is that correct?
73 Tom AA4VV
On 12/31/2011 3:48 PM, Barry N1EU wrote:
> Thanks - it's uncharted territory in there but I think I managed to
> improve things. I was careful to record the original values before
> mucking around.
>
> 73, Barry N1EU
>
> On Sat, Dec 31, 2011 at 7:18 PM, AL7CR<al7cr@punakea.com> wrote:
>> Go to the RX menu and press the 15m band select key. This will bring up
>> a screen that allows you set the S meter in digital counts.
>>
>> AL7CR
>>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|