That brings up another "Fix it" that should be looked at. The O II S-meter
is extremely stingy below S-9, but way too generous above S-9. The results
of my tests on v 2.039d are at:
http://n6ie.com/Orion%20S%20meter%20descrep.htm
Ron Castro
N6IE
www.N6IE.com
Member:
REDXA NCCC
NCDXF ARRL
-----Original Message-----
From: tentec-bounces@contesting.com [mailto:tentec-bounces@contesting.com]
On Behalf Of Carl Moreschi
Sent: Saturday, December 31, 2011 5:55 AM
To: Discussion of Ten-Tec Equipment
Subject: Re: [TenTec] Orion s-meter calibration
It's all done in firmware. My software provides this but it's only for the
program S meter.
Carl Moreschi N4PY
121 Little Bell Dr.
Hays, NC 28635
www.n4py.com
On 12/31/2011 8:47 AM, Barry N1EU wrote:
> Does anyone know the procedure for calibrating the Orion s-meter? Are
> there hardware pots that can be adjusted?
>
> Thanks& Happy New Year,
> Barry N1EU
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|