If you're replacing any series coupling caps in the AF section of the
IF/AF board that audio passes through, I would use film caps and not
electrolytic/tantalum with the exception of the big cap on the output
of the af amp (electrolytic).
GL/73,
Barry N1EU
On Thu, Dec 15, 2011 at 10:06 PM, <scottsheppard@videotron.ca> wrote:
> I think I will begin on the logic board and then go after the IF Board...the
> before and after will be monitored on an audio analyzer into the
> computer...unless I get ambitious and take it to work and use the test gear
> there...regardless, it will give me a few hours of soldering and the illusion
> of improving the rig. hi.
>
>
>
>
> scott
>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|