I know this topic has been discussed to one extent or another but there has
been little feedback in terms of how the perceived 'improvements' were measured.
Given I was putting an order in for some parts for the Corsair Display board
anyway, I ordered some extra 'audio grade' electrolytic caps and a few
tantalum. caps of lower values (1 uf etc) for replacement...
Any ideas of how best to do a before and after test? I was actually thinking of
just doing a short video of how the rig sounds (no antenna) before and after...
appreciate any thoughts you may have as well what boards may benefit first from
the change....I am sure I will notice a difference if only in my head :)
scott VA3IED
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|