TenTec
[Top] [All Lists]

Re: [TenTec] Omni 6+ mute?

To: wa3fiy@radioadv.com, Discussion of Ten-Tec Equipment <tentec@contesting.com>
Subject: Re: [TenTec] Omni 6+ mute?
From: Ken Brown <ken.d.brown@hawaiiantel.net>
Reply-to: ken.d.brown@hawaiiantel.net, Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Thu, 24 Nov 2011 09:27:20 -1000
List-post: <tentec@contesting.com">mailto:tentec@contesting.com>

> Yes I have tried it...just now, and it does work very well.

> 

>> Thanks but have you actually tried it?
>>
>> My mute jack does NOT mute the receiver when grounded.
>>
Then your Omni VI is broken. Repairing the Omni VI to make the mute 
input function properly is probably preferable to building a workaround.

The mute input may not work because someone has modified the rig to use 
the mute jack for some other function, or because something was 
connected there that should not have been and damaged the rig.

Look at "FIGURE 4-18. CONTROL BOARD SCHEMATIC (81596)"
Check to see if D17 is intact. If it has not been removed then check to 
see if it is any good.

If someone modified the rig to use that jack for some other purpose I 
would expect to see D17 missing, and a wire connected from the J3 end 
D17 solder pad to whatever it is they wanted access to. In that case 
remover the wire and replace D17.

If it was damaged I would expect D17 to be open circuit. In that case 
replace D17.

DE N6KB
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>