Greetings all.
My Omni VI/O3 has a MUTE jack on the rear panel which will mute the receiver
when
asserted. According to the manual "Whenever the MUTE line goes to ground, a
MUTE RQ
signal is...sent to the Logic board....This causes the transceiver to be placed
into transmit
mode, except that NO RF IS APPLIED until either the KEY or PTT lines are
grounded."
Does the 6+ have the same thing?
Happy Thanksgiving!
-Lee-
WA3FIY
On 24 Nov 2011 at 1:27, Barry N1EU wrote:
> Does anyone know a way to mute the Omni 6+ when in cw receive with an
> external control line?
>
> I just want to use Omni 6+ in receive mode, as an auxiliary receiver
> tuned to the same frequency as the transmitting radio. I've worked
> out the antenna switching but I still need to mute the Omni 6+ while
> the other radio is transmitting. Any ideas or kludges?
>
> Thanks & 73, Barry N1EU
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|