Thanks for the responses.
Carl, I tried this and the problem is that even though the power is
set to zero, the Omni 6+ is putting out a very low power signal that
I'm hearing interfering with the other radio's sidetone. This scheme
would work if I was only listening to the Omni 6+ (mono) but I'm
listening to the other radio in one ear and the Omni 6+ in the other
ear (stereo). Another issue is that it generates sidetone in the Omni
6+ and the Omni 6+ sidetone is not pleasant to listen to with all its
switching artifacts. Eventually I hope to tackle that issue - (the
"disconnect conn 52" solution doesn't work for me since I'm only using
dsp audio for sidetone and I need conn 52 gating)
Thanks for the suggestions James but none of them will do what I'm trying to do.
Happy Turkey Day to all,
Barry N1EU
On Thu, Nov 24, 2011 at 3:45 AM, Carl Moreschi <n4py2@earthlink.net> wrote:
> Set the power output to zero and use the cw key line connected to the
> other radio's amp key line.
>
> Carl Moreschi N4PY
> 121 Little Bell Dr.
> Hays, NC 28635
> www.n4py.com
>
>
> On 11/23/2011 8:27 PM, Barry N1EU wrote:
>> Does anyone know a way to mute the Omni 6+ when in cw receive with an
>> external control line?
>>
>> I just want to use Omni 6+ in receive mode, as an auxiliary receiver
>> tuned to the same frequency as the transmitting radio. I've worked
>> out the antenna switching but I still need to mute the Omni 6+ while
>> the other radio is transmitting. Any ideas or kludges?
>>
>> Thanks& 73, Barry N1EU
>> _______________________________________________
>> TenTec mailing list
>> TenTec@contesting.com
>> http://lists.contesting.com/mailman/listinfo/tentec
>>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|