Art here's a thought - are you using an RS-232 to USB converter? Somewhere in
the archives I'm sure you'll find discussion on the weird interactions of some
of the USB/Serial converters. I'd suggest you look for a a computer with a
"real" serial port and try another install.
Good luck!
73,
Rick
VE7TK
Website: http://www.ve7tk.com
--------------------------------------------------------------------------------
Subject: Re: [TenTec] Firmware download site
From: art davis <n4uc@hotmail.com>
Date: Tue, 4 Oct 2011 22:31:56 -0500
Curses, foiled again! I am now able to download the file (v. 2.064) from the
wiki site (thanks again)
and then use the update utility to load it to the radio. After loading all the
lines of code, the installer utility declares that the file was successfully
installed and the radio displays "SYSTEM LOADING" as it should. Then it asks me
about resetting filters and clearing memories. But no matter how I answer
either question it momentarily displays "SYSTEM LOADING" again and then asks
the questions again. It repeats all this cycle and never gets to the
operational mode where it displays 14.250. I was able to install this version
back when it first was released, but had the
same problem. I remember I had to repeat several installs before it magically
worked for some reason. So far, I haven't been so lucky this time. In
comparison, both of the previous two versions (2.062 and 2.063) load
correctly with no issues. I read a couple of posts where it was suggested that
the memory battery might
be low which could affect the bootup. My snaphat memory battery reads 3.1 V
which indicates to me that it was probably replaced when the factory performed
the v. 2 upgrade. Lastly, when I do a "verify program", the update utility
indicates that the
load is correct and successfully installed. Any ideas about why one version
would install and one not?
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|