Yes, that is correct. Where it is pulling the default value from I am not
certain, nor am I certain that everyones default values are the same, however,
what is key is that it is returning some default other than last setting when
the radio was turned off.
Thank you for taking a few minutes to confirm, perhaps there are others who
will still confirm and advise so were sure.
Steve - W5JK
On Jun 17, 2010, at 3:15 PM, Rsoifer@aol.com wrote:
> I tried it a few times. When power is turned back on, it resets to
> default values of 100 on CW and 3000 on SSB. Definitely a bug.
>
> 73 Ray W2RS
>
>
> In a message dated 6/17/2010 6:00:33 P.M. GMT Standard Time,
> skline4@verizon.net writes:
>
> Last night I observed a problem somewhat similar to what Rick is
> describing.
>
> I noticed that what ever setting the variable BW is reading prior to
> shutting the radio off is not the same BW setting that is restored if you
> turn
> the radio off and then turn it back on. For example if I was in SSB mode,
> with BW set to 3000 and then turn the radio off and then back on; after
> boot-up the BW setting may come up as 2480 or some other number but not 3000
> where it was at prior to shut down. Same occurs in CW mode, and can be
> replicated.
>
> Maybe related to same problem below. Can anyone else validate the power
> on/off sequence and confirm if their BW setting was restored to same value
> as it was before turning the power off?
>
> Thanks
> Steve - W5JK
>
> On Jun 17, 2010, at 8:39 AM, Rick Borken wrote:
>
>> Here are three bugs which I have found in the recent 2.044A firmware
> update.
>> I have reported them to Ten-Tec:
>>
>> The fix "fixed restoration of bandwidth when recalling USER memory" does
> not
>> work correctly in v 2.044A. It behaves differently than it did in 2.043,
> but
>> it is still incorrect.
>> When I recall a USER memory, the bandwidth always gets set to 1000 Hz
> for
>> CW, 2400 Hz for FSK and 100 Hz for SSB. It
>> does not reset to the value I tried to store in a USER memory.
>>
>> When I push the RECALL button and then recall the Factory Default USER
>> settings, the resulting screen shows PWR set to 100, and the value of
> PWR
>> is "frozen,"
>> and cannot be changed in the normal way by highlighting the
>> value and adjusting it with the MULTI knob.
>>
>> in v 2.044A, the value of "AGC Hang" is not restored to the value
> stored in
>> the USER memory when recalling a USER memory.
>>
>> 73, Rick K0XB
>>
>>
>>
>>
>>
>> _______________________________________________
>> TenTec mailing list
>> TenTec@contesting.com
>> http://lists.contesting.com/mailman/listinfo/tentec
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|